Eldes EKB3 Manuel d'installation télécharger pdf (Page 131)

131

131EN

MANUAL ELDES ESIM264 V3.1

32.4. EWD1 – Wireless Magnetic Door Contact

Main EWD1 features:

• Violated zone detection by magnetic contact;

• Panic button.

EWD1 is a wireless device with magnetic contact and panic button which is used to secure doors, windows or any other opening parts and

it operates with ELDES wireless alarm systems. EWD1 is bind to ESIM264 alarm system by sending a corresponding command via SMS text

message or using software ELDES Conguration Tool. When EWD1 is connected to the system, two wireless zones are added. First wireless

zone is used to monitor the magnetic contacts and the second wireless zone is for managing the panic button. By default panic button zone is

congured as Silent zone and in case the panic button is pressed, the system causes silent alarm (no siren is activated).

It is possible to connect up to 16 EWD1 devices to ESIM264 alarm system at a time. The maximum wireless connection range is 150 meters (in

open areas).

32.4.1. Technical Specications

32.4.1.1. Electrical & Mechanical Characteristics

Battery Type CR2032 3V Lithium

Number of Batteries 1

Battery Operation time 15 months*

Wireless Transmitter-Receiver Frequency 868 Mhz

Range of Operating Temperatures -20...+55ºC

Door Contact Dimensions 60x37x18mm

Humidity

0-90% RH @ 0... +40 °C (non-condensing)

Magnet Dimensions 60x17x16mm

Wireless Communication Range Up to 30 meters in premises; up to 150 meters in open areas

Compatible with Alarm Systems ELDES Wireless

* The operation time depends on dierent conditions and may vary.

32.4.2. Installation

1. Open EWD1 enclosure and insert the battery (Fig. No. 62).

CR2032

RESET

LED

2. EWD1 consists of two parts: a magnet and a sensor. Sensor components are: a mounting part and the sensor. Magnet components are:

a mounting part and the cover.

2.1 Fix the sensor mounting part with two screws on the door or window jamb.

2.2 Fix the magnet mounting part with two screws next to the sensor mounting part on door or window frame. The correct xing position

is indicated in Fig. No. 63.

MAX 20 mm

NOTE: The distance between magnet and sensor can be up to 20 mm only.

2.3 The sensor should be attached to the xed sensors mounting part. When attaching sensor pay attention to the tamper (micro switch)

- it must be pressed.

2.4 The magnet cover should be attached to the xed magnet mounting part.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 167 168

Commentaires sur ces manuels

Pas de commentaire

Eldes EKB3 Manuel d'installation Page 131

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Eldes EKB3