
104
104 EN
MANUAL ELDES ESIM264 V3.1
Set test period
EKB2
Menu path:
OK → CONFIGURATION → OK → aaaa → OK → MS SETTINGS → OK → GPRS SETTINGS → OK
→ TEST PERIOD → OK → tteessttpp → OK
Value: aaaa – 4-digit administrator password; tteessttpp – test period, range – [0... 65535]
seconds.
EKB3
Enter parameter 46 & number of attempts:
46 tteessttpp #
Value: tteessttpp – test period, range – [0... 65535] seconds.
Example: 46120#
Cong
Tool
This operation may be carried out from the PC using the ELDES Conguration Tool software.
NOTE: 0 value disables test period.
Unit ID is a 4-digit number (By default – 0000) required to identify the alarm system unit by EGR100 middle-ware. It is MANDATORY to
change the default Unit ID before using EGR100.
Set unit ID
EKB2
Menu path:
OK → CONFIGURATION → OK → aaaa → OK → MS SETTINGS → OK → GPRS SETTINGS → OK
→ UNIT ID → OK → unid → OK
Value: aaaa – 4-digit administartor password; unid – 4-digit unit ID number.
EKB3
Enter parameter 47 & unit ID number:
47 unid #
Value: unid – 4-digit unit ID number.
Example: 472245#
Cong
Tool
This operation may be carried out from the PC using the ELDES Conguration Tool software.
View GPRS network
settings
SMS
SMS text message content:
ssss_SETGPRS?
Example: 1111_SETGPRS?
Cong
Tool
This operation may be carried out from the PC using the ELDES Conguration Tool software.
NOTE: Kronos NET/Kronos LT software communicates via TCP protocol, while EGR100 middle-ware v1.2 and up supports both – TCP and
UDP protocols. However, TCP protocol is NOT recommend to use with EGR100.
ATTENTION: It is necessary to restart the system locally by powering down and powering up the system the system or remotely (see 33.
REMOTE SYSTEM RESTART) after changing the IP address or switching from TCP to UDP.
Commentaires sur ces manuels