Eldes ESIM364 Manuel d'utilisateur télécharger pdf (Page 19)

MANUAL ELDES ESIM364 V1.3 19

3.2.6 Arm by EKB3 Keypad

EKB3

ATTENTION: Your alarm system installer must enable keypad partition switch feature before you can use it.

ATTENTION: The following procedure is described based on 4-partition mode operation on EKB3 keypad. If your

alarm system installer has enabled 2-partition mode, the arming procedure using EKB3 keypad will be carried out

identically to EKB3W wireless keypad. For more details on 2-partition mode, please refer to 3.2.8. Arm by EKB3W

Keypad.

1. a) To arm a system partition that the keypad is assigned to, enter any out of 29 available 4-digit user codes or

master code using the number keys:

Enter user/master code:

uuuu

Value: uuuu – 4-digit user or master code

Example: 2222

b) To arm a dierent system partition, switch the keypad partition by pressing and holding the [1]... [4] key for 3

seconds until you will hear 3 short beeps:

Switch keypad partition:

Hold the [1]... [4] key and release it after 3 short beeps:

Value: [1]... [4] key – parition number 1... 4

After switching the keypad partition, enter any out of 29 available 4-digit user codes or master code using the

number keys:

Enter user/master code:

uuuu

Value: uuuu – 4-digit user or master code

Example: 2222

c) To arm multiple partitions simultaneously, press and hold the [0] key until you will hear 3 short beeps. Then

enter any out of 29 avaialable 4-digit user codes or master code using the number keys:

Hold the [0] key, release it after 3 short beeps and enter user/master code:

0 uuuu

Value: uuuu – 4-digit user or master code.

Example: 0 2222

2. The keypad indicator ARMED and [1]... [4] key, corresponding the partition number that is being armed, will

light ON and the system will initiate the exit delay countdown (by default – 15 seconds) intended for user to

leave the secured area. The countdown is indicated by short beeps emitted by keypad buzzer and the buzzer

connected to the alarm system (if any).

3. When the system is successfully armed, it will reply with conrmation by SMS text message to the rst preset

user phone number (by default), assigned to the same partition as the user/master code.

Fig. No. 14

User

ESIM364

SMS

4. When attempting to arm the system in case of violated zone / tamper presence, the system will not permit to arm

it. For more details on how to view the violated zone / tamper number, please refer to 3.4 Alarm Indications and

Viewing Violated Zones / Tampers. For more details on how to arm the system in case of violated zones presence,

please refer to 3.5 Bypassing and Activating Zones.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Eldes ESIM364 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Eldes ESIM364