126
126 EN
MANUAL ELDES ESIM364 V1.0
AUX+ Positive power supply terminal
AUX- Negative power supply terminal
G RS485 interface for communication (green wire)
Y RS485 interface for communication (yellow wire)
COM Common terminal for Z1
Z1 Security zone terminal
Z2 N/A
1 2 3
4 5 6
7
ARMED
READY
SYSTEM BYPS
A B
1
2
3
4
5
6
7
8
9
10
11
12
8 9
*
0 #
STAY
BYPS
INST
CODE
FRONT SIDE
Z2 Z1
COM Y
G
AUX-
AUX+
ON
OFF
DIP SWITCH
TAMPER
BACK SIDE
45
32.1.2.1.5 Keypad Address
DIP switches located on the back side of the keypad are intended to set keypad address. The keypad address is congured by setting the DIP
switch positions. ESIM364 alarm system allows to connect up to 4 EKB3 keypads - each set under dierent address. DIP switch combinations
for dierent keypad address conguration are indicated in the table below.
Address Conguration
DIP switch position Address
Keypad 1
Keypad 2
Keypad 3
Keypad 4
NOTE: Third switch is not active, therefore its’ position is irrelevant.
The address of each connected keypad is also indicated in ELDES Conguration Tool software.
32.1.2.2. Installation
1. Detach keypad holder from EKB3 keypad . Keypad holder detach points are marked with arrows (see Fig. No. 46).
Commentaires sur ces manuels